Stepper Motor Controller, DC 5-12V/15-160V Stepper Motor Controller PWM Pulse Generator Speed Regulator Board

Description:This controller can generate a PWM functions, the board has a jumper, you can set the default selection provided in the pulse frequency .Specification:Power supply voltage: 15-160V / 5-12VFrequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZSize: Approx. 73 x 51 x 37mm / 2.87 x 2 x 1.45inchWeight: 50gQuantity: 1pcPackage List:1 x PWM GeneratorNote:1.If you use to start or stop the function, controller enable terminal must be connected to common cathode or common anode drive.2. Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering

• This module is supplied as a stepper drive . To control the stepper motor, but also must have the drive to use.
• The controller has high, medium and low total of three types of frequency can be used to select jumper. The speed of the motor can be controlled by adjusting the frequency of the potentiometer.
• Frequency of measurement can amount PUL and common cathode terminal (GND) two ports. The forward and reverse of the motor can be controlled by pressing the key.
• PUL + and PUL‑ pulsed positive and negative; EN + and EN‑ is to enable the positive and negative terminals; DIR + and DIR‑ are the positive and negative directions. These six lines are connected to drive the corresponding pulse, direction, so six ports p
• Power supply: 15‑160VDC or 5‑12VDC. If you are using 5‑12VDC power, positive end connect DC 5‑12V Input, negative end connect Common Cathode End.